Sony RM-V701 Bedienungsanleitung PDF herunterladen

3-864-792-11(1)

RM-V701A/801

Remote Commander

Operating Instructions

Manual de instrucciones (parte posterior)

English

For the customers in the U.S.A.

WARNING

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that any changes or modifications not expressly

approved in this manual could void your authority to operate this

equipment.

About This Manual

The instructions in this manual are for RM-V701 and RM-VBOl.

Before you start reading, check your n'^odel number. RM-V701 is the

model used for illustration purposes. Any differences in operation

are clearly indicated in the text, forexarhpie, ■"RM-V701 only."

Setting Up the Remote Commander

Before you can start using the Commander, vou must first set it up.

This manual describes everything vou need to know to set up the

Commander, including:

• Preparing the batteries.

• Presetting the Commander with the codes for your TV, VCR, Cable

box, DBS tuner, and other audio components.

About Presetting the Commander

The Commander is preset at the factory to operate Sony brand

components.

If you're using the Commander with a Sony component, you won't

need to preset the Commander before you start using it.

To set up the Commander to use with other (non-Sony)

manufacturers' components, or to use with a component that is not

preset at the factory, you'll need to follow the instructions in this

manual to preset the Commander with the correct code number for

your components. (See the supplied "Component Code Numbers"

also.)

Position

Factory setting Component that can be preset

VISUAL

Sony TV

CABLE

—

Cable box/DBS tuner/Receiver

(AmpUfier)/CD player/Tape deck/

AVI /DBS Sony DBS tuner

MD deck/DAT deck/TV/VCR

VCR Sony VHS VCR

(VTR3)

VCR

Position Factory setting Component that can be preset

AUDIO

AMP Sony receiver

TAPE

Sony tape deck

Cable box/DBS tuner/Receiver

AV2

Sony MD deck

MD deck/DAT deck/TV/VCR

CD Sony CD player

Notes

• The Commander can be set up to operate only one component on

each position of the slide switch - unless their code numbers

happjen to be the san\e. For example, you cannot set up the

Commander to operate a Sony TV and a Panasonic TV

simultaneously (because they use different code numbers).

• You may not be able to operate even a Sony brand component with

the factory presetting. In such a case, follow the procedure in

"Setting the Code."

installing the Batteries (RM-V701 only)

Slide open the battery compartment and insert two size AA (R6)

batteries (not supplied).

Be sure to line up the + and - on the batteries with the + and - on the

battery compartment.

When to replace the batteries

Under normal conditions, batteries will last up to six months. If the

Commander does not operate properly, the batteries might be worn

out. Replace the batteries with new ones.

Notes

• Replace both batteries with new ones.

• Do not take more than 20 minutes to replace the batteries;

otherwise, your setting of the code numbers will be erased.

Notes on Batteries

• Do not mix old batteries with new ones or mix different types of

batteries together.

• If the electrolyte inside the battery should leak, wipe the

contaminated area of the battery compartment with a cloth and

replace the old batteries with new ones. To'prevent the electrolyte

from leaking, remove the batteries when you plan not to use the

Commander for a long period of time.

Charging the batteries (RM-V801 only)

Before operating the Commander

Bo sure to set the start switch at the rear to ON using a bail-point pen

tip, etc.

Start switch

1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - RM-V701A/801

Seite 2 - Positions

TV/VCR/COMBOBrandSonyComponent Code No.VCR 01 (VTRl: Beta)02 (VTR2: 8 mm)03 (VTR3: VHS)04 (VTR4: DV)05 (VTR5: DV)06 (VTR6: DV)TV01AdmiralVCR30TV02,

Seite 3 - 6 to assign a tape deck

CBLCDBrandCode No.BrandCode No.Hamlin/Regal22, 23, 24, 25, 26Sony01Jcrrold/G.I.01, 02, 03, 04,05, 06, 07, 08, 18Aiwa30, 32Oak27, 28, 29Denon24Panasoni

Seite 4 - 8 selects TV

MD/DAT (RM-V40AA/701A^801)BrandCode No.Sony01, 09 (DAT)Denon02Kenwood03Teac04Panasonic05Marantz06JVC07Sansuí08Pioneer10 (DAT)Onkyo10 (DAT)Mini Hi-Fi c

Seite 5 - Preparación del telemando

Do not attempt to change the position of the switch after you have sot it. Doing so may erase the preset component code numlx'r stored in the mem

Seite 6 - Búsqueda del código correcto

©0T**C3©®®®Press and release one of the following buttons;1 to assign a VCRA to assign a receiver (or amplifier)5 to assign a CD player6 to assign a t

Seite 7 - Solución de problemas

Remote Button DescriptionsRM-V701RM-V801GeneralÎT] To sot up the Commander. “Volume up: +Volume down: -[9I “To mute the volume on TV or receiver (ampl

Seite 8 - Especificaciones

EspañolPosición Ajuste de fábricaPara los clientes de EE. UU. ADVERTENCIAEste equipo ha sido probado y se ha encontrado que cumple con los límites par

Seite 9 - No7] ^ (enter^

VISUALAUDIOГЖ”IIICíqAVUdeS'*«VCR-I-írTAPt^-Aval-CONotas• Cordóroso de mantener el telemando encarado hacia arriba y en un lugar bien ventilado.

Seite 10 - TV/VCR/COMBO

7 Introduzca el número de código del componente siguiendo los pasos 4 a 7 de "Introducción del número de código", o los pasos 1 a 7 de &quo

Seite 11 - DBS (RM-V40A/V701A/801)

Descripción de las teclas del telemandoRefiérase a Ja ilustración del RM-V701 o RM-V801 de la sección "Remote Button Descriptions" del manua

Seite 12 - Codes de minichaine hifi

Verwandte Modelle: RM-V801

Kommentare zu diesen Handbüchern

Keine Kommentare

Sony RM-V701 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Schalttafel Sony RM-V701 herunter. Sony RM-V701 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: RM-V801

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schalttafel Sony RM-V701