Sony DMX-R100 Bedienungsanleitung PDF herunterladen (Seite 20)

Automation Operation

Trimming Cut Switches

The trim functions for cut switches allow individual

cut transactions to be time-shifted earlier or later, or

erased.

Note

Automation data must already be present ahead of any

points where TRIM operations might be carried out.

1 Press {TRIM} on the panel under the TC

AUTOMATION heading above the timecode

display. The AUTO button in the middle at the top

of the GUI turns green and indicates ‘TRIM’ at the

lower left.

2 Touch {READYSETUP} to the right of the AUTO

button and it highlights.

3 Press each {CUT} button to be trimmed and note

that they do not change state. Their channel

{WRITE} buttons flash on and off red with a fast

double flash in the red part of the cycle. This

indicates that the cuts are ready to have any switch

operations recorded by the automation system.

The fast double flash serves as a reminder that

{READYSETUP} is selected.

The ready status of any switch is also displayed in

the CHANNEL GUI in the same way as when

using the ‘ABS’ mode for automating cuts.

4 Then touch {READYSETUP} to de-select it, or roll

the material in which case it will be de-selected

automatically. When {READYSETUP} is off, the

{WRITE} buttons will flash regularly without the

double flash. The regular flashing indicates the

normal automation ready mode.

5 Once the material is rolling, cuts can be adjusted in

a number ways according to the illustrations that

follow:

A - Shows the original cut actions.

B - Press and release {CUT} before original cut

point to advance the cut on-point. Press and

release {CUT} before the original off-point to

advance the cut off-point. These operations can be

performed independently in one or two passes.

C - Press and hold {CUT} from before the original

cut point, and release after to delay the cut

CUT button ON/OFF:

ON OFF

Previous cut data

New cut operations

ORIGINAL CUT ACTIONS

CUT ON

EARLIER

CUT OFF

EARLIER

CUT ON

LATER

CUT OFF

LATER

push

release

press, hold

& release

ERASE CUT TRANSACTION COMPLETELY

press, hold

& release

press & hold release

CUT

Signal

on-point. Press and hold {CUT} from before the

original off-point, and release after to delay the cut

off-point. These operations can be performed

independently in one or two passes.

D - Press and hold {CUT} from before the original

cut point, and release after the original cut

off-point to erase a cut transaction completely.

Automating Other Switches

The principles of operation for cut switches apply

equally to all other types of switches. They can be set

into automation ready by pressing switches on the

panel, or by touching buttons on the zoomed GUIs.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Sony DMX-R100 Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Sony DMX-R100