Sony PEGA-WL100 Bedienungsanleitung

4-668-080-11 (1)Wireless LAN CardOperating Instructions 2002 Sony CorporationPEGA-WL100

10Inserting/Removing the Wireless LANCardInserting the Wireless LAN card in your CLIÉhandheldInsert the Wireless LAN card in Wireless Communication Sl

11Removing the Wireless LAN card from your CLIÉhandheldAfter use, terminate communications. Then, pull the wireless LANcard up straight.When using thi

12Installing the SoftwareWhen you try to perform wireless LAN communications for the firsttime after inserting the Wireless LAN card in your CLIÉ hand

134 Click [Done] when the installer-closing screen appears.Your computer is ready to install the Wireless LAN utility to yourCLIÉ handheld. In the nex

14Performing Communications via aWireless LAN Access Point(Infrastructure Mode)You can wirelessly access the Internet or perform communicationswith ot

154 Tap V of [Service], and select [Wireless LAN].5 Tap [Details...] in the lower left corner of the screen.The [Wireless LAN Setup] screen appears.6

16TipTapping the mark in the upper right corner of the screen shows a briefexplanation for the setting.7 Enter a profile name in [ProfileName].Speci

179 Select the encryption level in [WEP].WEP (encryption level) is fixed depending on the access point youuse. Be sure to select the encryption that i

18When you select 40/64bit: alphanumeric string (5 characters)Enter a 5-digit password using alphabet (a-z), numbers (0-9) andsymbols.When you select

19Modifying the settings1 Tap the [Prefs] icon on the home screen of your CLIÉ handheld.The [Preferences] screen appears.2 Tap V in the upper right co

2Owner’s RecordThe model number and serial number are located at the rear of theproduct. Record the model number and the serial number in the spacepro

20Advanced SettingsSetting a network manuallyWhen it is necessary to set a network IP address or DNS address,follow the procedure below.1 Tap [Advance

21Connecting your CLIÉ Handheld to a Wireless LAN1 Insert the Wireless LAN card in WirelessCommunication Slot of your CLIÉ handheld.2 Tap the [Prefs]

225 Tap [Details...] in the lower left corner of the screen.The [Wireless LAN Setup] screen appears.6 Tap V below [Profile Name], and select the profi

23Performing Communications Directlybetween your CLIÉ Handheld andAnother Device on a Wireless LAN(Ad-Hoc Mode)Your CLIÉ handheld can communicate dire

245 Tap [Details...] in the lower left corner of the screen.The [Wireless LAN Setup] screen appears.6 Tap [Create].A new input screen of [Wireless LAN

258 Enter a network ID in [NetworkID (SSID)].Specify an alphanumeric string freely. The same network ID(SSID) needs to be entered in both your CLIÉ ha

2610Enter a WEP key.Be sure to enter the same WEP key in both your CLIÉ handheldand the other communication device.For details on WEP key, see pages 1

2712Tap V of [ch] below [Adhoc], and select a channel.Be sure to select the same channel for both your CLIÉ handheldand the other communication device

2815Enter an IP address and a sub-netmask.Enter different IP addresses in your CLIÉ handheld and the othercommunication device.Enter the same Subnet m

29Modifying the settings1 Tap the [Prefs] icon on the home screen of your CLIÉ handheld.The [Preferences] screen appears.2 Tap V in the upper right co

3Declaration of ConformityTrade Name : SONYModel No. : PEGA-WL100Responsible Party : Sony Electronics Inc.Address : 1 Sony Drive, Park Ridge, NJ 07656

30Connecting your CLIÉ Handheld to Another Deviceon a Wireless LAN1 Insert the Wireless LAN card in WirelessCommunication Slot of your compatible CLIÉ

315 Tap [Details...] in the lower left corner of the screen.The [Wireless LAN Setup] screen appears.6 Tap V below [Profile Name], and select the profi

32Performing a HotSync Operation via aNetwork with a Wireless LAN CardThis Wireless LAN card can be used in various ways. For example,you can perform

332 Rotate the Jog Dial navigator to select HotSync and press theJog Dial navigator on the Application Launcher screen.The [HotSync] screen is display

34TroubleshootingIf any problem occurs, for example, if communication is not possible,or if the unit does not operate normally, please check the point

35SymptomYou cannot connectyour CLIÉ handheld toan access point.You cannot access theInternet.The data transfer rate isslow.Cause/Remedy• Your CLIÉ ha

36SymptomThe data transfer rate isslow.You forget a WEP(encryption) key.You cannot send orreceive email.You cannot perform aHotSync operation.You cann

37Precautions on UseHandling this Wireless LAN Card•Do not subject the card to excessive shock, and take care not to dropit to prevent malfunction.•Do

38SpecificationsPower sourcePowered by CLIÉ handheldPower consumptionWhen transmitting: Approx. 560 – 920 mW (typ)*Idle: Approx. 90 mW (typ)** At the

39

4To prevent radio interference to the licensed service, this device isintended to be operated indoors and away from windows to providemaximum shieldin

Printed in JapanPrinted on 100% recycled paper usingVOC (Volatile Organic Compound)-freevegetable oil based ink.Customer SupportFor the latest support

5• Sony, , CLIÉ, , CLIÉ GEAR, , , JogDial and Memory Stick are trademarks of Sony Corporation.• Palm OS and HotSync are registered trademarks o

6Table of ContentsIntroduction ... 7Names of Parts ...

7IntroductionThis product is a Wireless LAN Card for the Sony PersonalEntertainment Organizer (mentioned as CLIÉ handheld after this) ofthe Palm OS 5

8Accessing the InternetYou can access the Internet from your CLIÉ handheld in which thisWireless LAN card is inserted through a LAN access point, and

9Names of PartsWireless LAN CardFrontRearOther items includedCD-ROM (1)Hard case (1)Operating Instructions (1)Warranty card (1)End-User’s License Agre