Sony STR-DN1030 Bedienungsanleitung PDF herunterladen (Seite 103)

103

GB

D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF

06\4420298122_GB_AU1\GB06REM_STR-DN1030-CEL.fm

masterpage: Right

STR-DN1030

4-420-298-12(2)

Using the Remote Control

3 Press the numeric buttons to

enter the numeric code.

If more than one code exists, try to enter

either one which corresponds to the

equipment including TV.

Use the tables on page 103–106 to find

the numeric code(s) corresponding to the

equipment.

Note

Only the codes in the 500’s are valid for the TV

button.

4 Press ENT/MEM.

Once the numeric code has been verified,

the RM SET UP button slowly flashes

twice and the remote control

automatically exits the programming

mode.

5 Repeat steps 1 to 4 to program

other equipment.

Note

The RM SET UP button turns off while a numeric

button is pressed.

To cancel programming

Press RM SET UP during any step. The

remote control automatically exits the

programming mode.

To activate the input after

programming

Press the programmed button to activate the

input you want.

If programming is

unsuccessful, check the

following:

• If the RM SET UP button does not light up

in step 1, the batteries are weak. Replace

both batteries.

• If the RM SET UP button flashes 5 times in

quick succession while entering the numeric

code, an error has occurred.

Start again from step 1.

Use the numeric codes in the tables below to

program non-Sony equipment and also Sony

equipment that the remote control is normally

unable to control. Since the signal from the

remote control received by the equipment

differs by its model and the year, more than

one numeric code may be assigned to the

equipment. If you fail to program your remote

control using one of the codes, try using other

codes.

Notes

• The numeric codes are based on the latest

information available for each brand. There is a

chance, however, that your equipment will not

respond to some or all of the codes.

• All of the input buttons on this remote control may

not be available when used with your particular

equipment.

To control a CD player

To control a DAT deck

The numeric codes

corresponding to the equipment

and the maker of the equipment

Maker Code(s)

SONY 101, 102, 103

DENON 104, 123

JVC 105, 106, 107

KENWOOD 108, 109, 110

MAGNAVOX 111, 116

MARANTZ 116

ONKYO 112, 113, 114

PANAS ONIC 115

PHILIPS 116

PIONEER 117

TECHNICS 115, 118, 119

YAMAHA 120, 121, 122

Maker Code(s)

SONY 203

PIONEER 219

continued

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 127 128

Kommentare zu diesen Handbüchern

Keine Kommentare