34
Power ON Mechanical Sequence – No Disc
Operation Purpose
1. Power On button is pressed. IC202 retrieves start up pro
ram from Flash ROM IC205. After the
ICs are checked for basic communications
IC202 instructs Servo
IC701 to start the mechanical se
uence. The servo parameters are
stored in EEProm IC201.
2. Disc tra
is closed
if open
and placed into a
chucked position.
Clamps a disc on the spindle motor platform.
3. Sled moves the optical assembly to home position. Sled starting point.
4. Tilt Motor resets laser platform to mid position. Presets the laser beam perpendicular to the disc for max RF.
5. Sled moves outward quickly, then slows down. Optical assembly is moving under the disc’s information area.
6. Laser is turned ON momentaril
durin
focus
search.
Looks for a disc. Reflected light identifies a disc.
7. Focus search one time.
Optical assembl
lens moves up then down
lookin
for the disc’s
information layer.
8. Sled increases speed moving further outward. Sled slows down in a second attempt to locate a disc.
9. Sled slows down
10. Laser is turned ON momentaril
durin
focus
search.
Looks for a disc using reflected light.
11. Focus search. Looks for the disc’s information laye.
12. Sled a
ain moves
uickl
outward then slows
followed by laser and focus search.
Third attempt to locate a disc.
13. Sled moves inward to home and stops. Disc check at home position.
14. Laser is turned ON momentarily. Final attempt to identify a disc.
15. Focus search.
16. Spindle motor rotates. (laser is off)
17. Display reads NO DISC User feedback
Kommentare zu diesen Handbüchern