Sony STR-DA5300ES Betriebsanleitung PDF herunterladen (Seite 131)

131

GB

Additional Information

• Do not place the receiver near equipment

such as a television, VCR, or tape deck. (If

the receiver is being used in combination

with a television, VCR, or tape deck, and is

placed too close to that equipment, noise

may result, and picture quality may suffer.

This is especially likely when using an

indoor antenna (aerial). Therefore, we

recommend using an outdoor antenna

(aerial).)

On operation

Before connecting other components, be sure

to turn off and unplug the receiver.

On cleaning

Clean the cabinet, panel, and controls with a

soft cloth slightly moistened with a mild

detergent solution. Do not use any type of

abrasive pad, scouring powder, or solvent,

such as alcohol or benzine.

If you have any questions or problems

concerning your receiver, please consult your

nearest Sony dealer.

Troubleshooting

If you experience any of the following

difficulties while using the receiver, use this

troubleshooting guide to help you remedy the

problem. Should any problem persist, consult

your nearest Sony dealer.

Audio

There is no sound, no matter which

component is selected, or only a very

low-level sound is heard.

• Check that the speakers and components

are connected securely.

• Check that all speaker cords are connected

correctly.

• Check that both the receiver and all

components are turned on.

• Check that MASTER VOLUME control is

not set at –∞ dB. Try to set it at about –40

dB.

• Check that SPEAKERS (OFF/A/B/A+B)

is not set to OFF (page 46).

• Press MUTING on the remote to cancel

the muting function.

• Check that you have selected the correct

component with INPUT SELECTOR.

• Check that headphones are not connected.

• When only a very low-level sound is

heard, check to see if NIGHT MODE is

activated (page 73).

• The protective device on the receiver has

been activated. Turn off the receiver,

eliminate the short-circuit problem, and

turn on the power again.

There is no sound from a specific

component.

• Check that the component is connected

correctly to the audio input jacks for that

component.

• Check that the cord(s) used for the

connection is (are) fully inserted into the

jacks on both the receiver and the

component.

continued

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 141 142

Kommentare zu diesen Handbüchern

Keine Kommentare