Sony STR-DN1030 Bedienungsanleitung PDF herunterladen (Seite 112)

112

GB

D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF

06\4420298122_GB_AU1\GB07ADD_STR-DN1030-CEL.fm

masterpage: Left

STR-DN1030

4-420-298-12(2)

Recording cannot be carried out.

• Check that the equipment is connected

correctly.

• Select the source equipment using the

input buttons (page 49).

• Audio input signals via HDMI IN and

DIGITAL IN jacks cannot be recorded.

• Copyright protection to prevent recording

is contained in the sources. In this case,

you may not be able to record from the

sources.

A test tone is not output from the

speakers

• The speaker cords may not be connected

securely. Check to see if they are

connected securely and cannot be

disconnected by pulling on them slightly.

• The speaker cords may have short-circuit

problem.

• Make sure that you are not using PARTY

STREAMING function (page 73).

A test tone is output from a different

speaker than the speaker displayed on

the TV screen

• The speaker pattern set up is incorrect.

Make sure that the speaker connections

and the speaker pattern match correctly.

When the receiver is in standby mode,

there is no sound output from the TV.

• When the receiver enters into standby

mode, sound is from the last HDMI

equipment selection before you turned off

the receiver. If you are enjoying other

equipment, play the equipment and

perform the One-Touch Play operation, or

turn on the receiver to select the HDMI

equipment you want to enjoy.

• Make sure “Pass Through” is set to “ON”

in the HDMI Settings menu if you connect

equipment not compatible with the

“BRAVIA” Sync to the receiver (page 94).

There is a time gap between the audio

output and visual display.

• Check that the PARTY STREAMING

function is not being used. To close a

PARTY, press SHIFT, then hold down

PARTY until “CLOSE PARTY” appears.

For details, see page 73.

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM

antennas (aerial) as shown below.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas

(aerials) and connect an external antenna

(aerial), if necessary.

• The signal strength of the stations is too

weak with automatic tuning. Use direct

tuning.

• No stations have been preset or the preset

stations have been cleared (when tuning

by scanning preset stations is used). Preset

the stations (page 58).

• Press AMP, then press DISPLAY

repeatedly on the remote control so that

the frequency appears on the display

panel.

Tuner

Receiver

Outdoor FM antenna (aerial)

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 127 128

Kommentare zu diesen Handbüchern

Keine Kommentare