Sony MDS-PC1 Bedienungsanleitung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 132
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
11
EN
Recording on MDsRecording on MDs
When recording from DAT or satellite broadcasts
with INPUT at DIGITAL, the deck automatically
marks a track number whenever the sampling
frequency of the input signal changes.
When “TOC” flashes in the display
The deck is currently updating the Table Of Contents
(TOC). Do not move the deck or pull out the AC power
cord. Changes to an MD made through recording are
saved only when you update the TOC by ejecting the
MD or changing the deck to standby by pressing the
switch.
The MD deck uses the SCMS (Serial Copy
Management System on page 40)
MDs recorded through digital input connector cannot
be copied onto other MDs or DAT tapes through the
digital output connector.
When the deck is recording or in recording pause,
digital signals input through one of the digital input
connectors are output to the DIGITAL OUT
connector with the same sampling rate
To change the digital input signal to another sampling
rate for output (without recording it to an MD), use
Input Monitor Function (see page 12).
Notes on Recording
If “Protected” alternates with “C11” in the display
The MD is record-protected. Close the slot to record
on the disc (see “To protect an MD against accidental
erasure” on page 9).
If “CHECK OPT-IN” alternates with “C71” in the
display
The digital program source is not connected as you
set with the INPUT switch in Step 4 on page 8.
To continue, connect the program source properly.
The program source is not on.
Turn on the program source.
Depending on the menu settings and source being
recorded, track numbers are marked in following
ways:
When recording from a CD or MD with INPUT at
DIGITAL and the source connected through
DIGITAL IN:
The deck automatically marks track numbers in the
same sequence as the original. If, however, a track is
repeated two or more times (e.g. by single-track
repeat play) or two or more tracks with the same
track number (e.g. from different MDs or CDs) are
played, the track or tracks are recorded as part of a
single, continuous track with a single track number.
If the source is an MD, track numbers may not be
marked for tracks of less than 4 seconds.
When recording with INPUT at DIGITAL, the deck
may not automatically mark track numbers for some
CD players and multi disc players. In these cases,
mark the track numbers afterwards using the deck’s
Divide Function (see “Dividing Recorded Tracks” on
page 30).
When recording from source connected through
LINE (ANALOG) IN with INPUT at ANALOG, and
“LEVEL- SYNC” does not light up (see “Marking
Track Numbers while Recording” on page 14) or
when recording from DAT or satellite broadcasts
connected through DIGITAL IN with INPUT at
DIGITAL:
The source will be recorded as a single track. You
can divide the track afterwards using the Divide
Function on page 30 or mark track numbers during
recording by using the Track Marking Function on
page 14.
If “LEVEL-SYNC” appears in the display, the deck
automatically marks track numbers when recording
analog source or digital recording of DAT or satellite
broadcasts (see “Marking track numbers
automatically” on page 14).
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare