Sony ICF-C1IPMK2 Bedienungsanleitung PDF herunterladen

ICF-C1iPMK2_AU6/SP5 [GB] 3-873-060-94(1)

3-873-060-94(1)

FM/AM Clock Radio

ICF-C1iPMK2

Operating Instructions

Dream Machine is a trademark of Sony Corporation.

FM wire aerial

AC power cord

Display window (12-hour system )

The display differs depending on your country.

There is a tactile dot on the VOL +,

N/X, M and PRESET + button.

CR2032

CR2025

WARNING

To reduce the risk of fire or electric shock, do

not expose this apparatus to rain or moisture.

To reduce the risk of fire, do not cover the ventilation

of the apparatus with newspapers, tablecloths,

curtains, etc. And do not place lighted candles on the

apparatus.

The apparatus shall not be exposed to dripping or

splashing and no objects filled with liquids, such as

vases, shall be placed on the apparatus.

Do not install the appliance in a confined space, such

as a bookcase or built-in cabinet.

As the main plug is used to disconnect the unit from

the mains, connect the unit to an easily accessible AC

outlet. Should you notice an abnormality in the unit,

disconnect the main plug from the AC outlet

immediately.

WARNING

• Danger of explosion if battery is incorrectly

replaced. Replace only with the same or equivalent

type.

• Replace the battery for the clock backup with a

Sony CR2032 lithium battery, and the battery for the

remote commander with a Sony CR2025 lithium

battery. Use of another battery may present a risk of

fire or explosion.

• Battery may explode if mistreated. Do not recharge,

disassemble or dispose of in fire.

• Do not expose the batteries (battery pack or

batteries installed) to excessive heat such as

sunshine, fire or the like for a long time.

• Dispose of used battery promptly. Keep away from

children.

Precautions

• Operate the unit on the power source specified in

“Specifications”.

• To disconnect the power cord (mains lead), pull it

out by the plug, not the cord.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall

outlet, even if the unit itself has been turned off.

• Allow adequate air circulation to prevent internal

heat build-up. Do not place the unit on a surface (a

rug, blanket, etc.) or near materials (a curtain) that

might block the ventilation holes.

• Should any solid object or liquid fall into the unit,

unplug the unit and have it checked by a qualified

personnel before operating it any further.

• To clean the casing, use a soft cloth dampened with

a mild detergent solution.

• Do not connect the aerial lead to the external aerial.

• To reduce the risk of fire, do not cover the

ventilation of the apparatus with newspapers,

tablecloths, curtains, etc. And do not place lighted

candles on the apparatus.

NOTES ON LITHIUM BATTERY

• Wipe the battery with a dry cloth to assure a good

contact.

• Be sure to observe the correct polarity when

installing the battery.

• Do not hold the battery with metallic tweezers,

otherwise a short-circuit may occur.

If you have any questions or problems

concerning your unit, please consult your

nearest Sony dealer.

Features

• Dual alarm FM/AM Clock radio with iPod dock.

• Various type of alarms- iPod, radio and buzzer.

• SUMMER TIME button to adjust Daylight Saving

Time/Summer time.

• CLOCK button to display month, day and year.

• Brightness control (High/Middle/Low).

• Supplied CR2032 battery for backup power source

to keep the clock and alarm operating during a

power interruption.

Connecting the

aerial

To connect the AM loop

aerial

The shape and the length of the aerial is designed to

receive AM signals. Do not dismantle or roll up the

aerial.

1 Remove only the loop part from the plastic

stand.

2 Set up the AM loop aerial.

3 Connect the cords to the AM aerial

terminals.

The cords (A and B) can be connected to either

terminal.

Only insert up

to here.

4 Make sure the AM loop aerial is connected

firmly by pulling softly.

Adjusting the AM loop aerial

Find a place and an orientation that provide good

reception.

• Do not place the AM loop aerial near the unit or

other AV equipment, as noise may result.

• If you use an external polarized AM aerial, be sure

to connect the ground cord to the

terminal. The

supplied AM aerial cord has no polarity.

Tip

Adjust the direction of the AM loop aerial for best

AM broadcast sound.

Insert the cord while

pushing down the

terminal clamp.

About the backup

battery

To keep good time, as a backup power source, this

unit needs one CR2032 battery (supplied), in addition

to the house current.

The battery keeps the clock and the alarm operating in

the event of a power interruption.

Note that the backlight will not light up during a

power interruption.

Knowing when to replace

the battery

If the battery runs out during the interruption, the

current time and alarm functions will be initialized.

Replace the battery with a Sony CR2032 lithium

battery. Use of another battery may present a risk of

fire or explosion.

Installing and replacing the

backup battery

1 Keep the AC plug connected to the AC

outlet, remove the screw that secures the

battery compartment at the bottom of the

unit using a screwdriver, and remove the

battery compartment. (See Fig. A-1)

2 Insert a new battery in the battery

compartment with the e side facing up.

To remove the battery from the battery

compartment, push it out from the side marked

PUSH. (See Fig. A-2)

3 Insert the battery compartment back into the

unit and secure it with the screw.

(See Fig. A-3)

Note

When you replace the battery, keep the AC plug

connected to a wall outlet. Otherwise, current time

and alarms will be initialized if the replacement is not

completed within around one minute.

If the time in the display is

incorrect after the battery

is changed (RESET)

Push the Reset switch with the pointed device. The

Reset switch is in the small hole located in the battery

compartment.

Notes

• You cannot reset unless the lithium battery is

installed.

• Set the clock again after the unit is reset.

Battery Warning

When the unit will be left unplugged for a long time,

remove the battery to avoid undue battery discharge

and damage to the unit from battery leakage.

There is a tactile dot on the VOLUME +, N/X and PRESET TUNING 3 button.

Preparing the

remote commander

Before using the card remote commander for the first

time, remove the insulation film. (See Fig. B-1)

When to replace the battery

With normal use, the battery (CR2025) should last for

about six months. When the remote commander no

longer operates the unit, replace the battery with new

ones. (See Fig. B-2)

Notes

• Do not charge the battery.

• When you are not going to use the remote

commander for a long time, remove the battery to

avoid any damage caused by leakage and corrosion.

1 2

FM/AM Clock Radio 1

Inhaltsverzeichnis

Seite 1 - FM/AM Clock Radio

Seite 2

ICF-C1iPMK2_AU6/SP5 [GB] 3-873-060-94(1)Notes• The connector of the unit is for sole use for iPod.When you use the devices do not match with theconnec

Kommentare zu diesen Handbüchern

Keine Kommentare

Sony ICF-C1IPMK2 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Dockingstationen für mobile Geräte Sony ICF-C1IPMK2 herunter. Sony ICF-C1IPMK2 User manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Dockingstationen für mobile Geräte Sony ICF-C1IPMK2