Sony HT-NT3 Bedienungsanleitung PDF herunterladen (Seite 25)

25

GB

HT-NT3

4-559-516-15(1)

D:\NORM'S JOB\SONY HA\SO150038\HT-NT3 (PMRF 06)\4559516151_GB

(CEK)\050SET.fm

masterpage:

Right

Settings and Adjustments

If you set [Quick Start/Network Standby] to

[Off] and [Bluetooth Standby] to [On], the

system can be turned on by a BLUETOOTH

device, but BLUETOOTH connection fails.

 [Bluetooth Codec - AAC]

This function is only available when you

set [Bluetooth Mode] to [Receiver] or

[Transmitter].

[On]

: Enable AAC codec.

[Off]: Disable AAC codec.

You can enjoy high quality sound if the

AAC is enabled. In case you cannot listen

to AAC sound from your device, select

[Off].

If you change the [Bluetooth Codec - AAC]

setting when a BLUETOOTH device is

connected, the codec setting is only

reflected after the next connection.

 [Bluetooth Codec - LDAC]

This function is only available when you

set [Bluetooth Mode] to [Receiver] or

[Transmitter].

[On]

: Enable LDAC codec.

[Off]: Disable LDAC codec.

If you change the [Bluetooth Codec - LDAC]

setting when a BLUETOOTH device is

connected, the codec setting is only

reflected after the next connection.

LDAC is an audio coding technology

developed by Sony that enables the

transmission of High-Resolution (Hi-Res)

Audio content, even over a BLUETOOTH

connection. Unlike other BLUETOOTH

compatible coding technologies such as

SBC, it operates without any down-

conversion of the Hi-Res Audio content*,

and allows approximately three times

more data** than those other technologies

to be transmitted over a BLUETOOTH

wireless network with unprecedented

sound quality, by means of efficient coding

and optimized packetization.

* Excluding DSD format contents.

** In comparison with SBC (Subband

Coding) when the bitrate of 990 kbps

(96/48 kHz) or 909 kbps (88.2/44.1 kHz)

is selected.

 [Wireless Playback Quality]

You can set transmission data rate of

LDAC playback. This function is only

available when you set [Bluetooth

Mode] to [Transmitter] and [Bluetooth

Codec - LDAC] to [On].

[Auto]: The data rate is automatically

changed depending on environment. If

audio playback is unstable in this

setting, use other three settings.

[Sound Quality]: The highest data rate is

used. Sound is sent in the higher quality,

however audio playback sometimes

may become unstable when the link

quality is not good enough.

[Standard]

: The middle data rate is

used. It balances both sound quality

and playback stability.

[Connection]: Stability is prioritized.

Sound quality may be reasonable and

connection status will most likely be

stable. If the connection is unstable, this

setting is recommended.

Note

Note

Note

Tip

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare