Sony DVP-NS708H Bedienungsanleitung PDF herunterladen (Seite 16)

16

Note

When connecting to a progressive TV, it is

recommended that you use only pattern C. If you

connect to your TV using both C and D, a special

control signal transmitted via the SCART cable

may cause the signal to be switched to the SCART

jack.

A Video input jack

You will enjoy standard quality images.

B HDMI/DVI input jack

Use a certified Sony HDMI cord to enjoy

high quality digital picture and sound through

the HDMI OUT jack.

When connecting to a Sony TV that is

compatible with the CONTROL FOR HDMI

function, see page 17.

When connecting to the HDMI OUT jack

Follow the steps below. Improper handling

may damage the HDMI OUT jack and

the connector.

1 Carefully align the HDMI OUT jack on

the back of the player and the HDMI

connector by checking their shapes.

Make sure the connector is not upside

down or tilted.

2 Insert the HDMI connector straight into

the HDMI OUT jack.

Do not bend or apply force to the HDMI

connector.

To connect to a TV with DVI input

Use an HDMI-DVI converter cord (not

supplied). The DVI jack will not accept any

audio signals, so you have to use another

audio connection in addition to this

connection (page 18). Furthermore, you

cannot connect the HDMI OUT jack to DVI

jacks that are not HDCP compliant (e.g., DVI

jacks on PC displays).

C Component video input jacks

(Y, P

B/CB, PR/CR)

You will enjoy accurate colour reproduction

and high quality images.

If your TV accepts progressive 525p/625p

format signals, use this connection and set

“PROGRESSIVE (COMPONENT OUT

ONLY)” in “SCREEN SETUP” to “ON”

(page 58) to output progressive signals.

D SCART input jack

Be sure to make the connections firmly to

avoid hum and noise. When you connect

using the SCART cord, check that the TV

conforms to S video or RGB signals. Refer to

the operating instructions supplied with the

TV to be connected. Also, when you set

“LINE” to “S VIDEO” or “RGB

(COMPONENT OFF)” under “SCREEN

SETUP” in the Setup Display (page 58), use

a SCART cord that conforms to each signal.

When connecting to a standard 4:3 screen

TV

Depending on the disc, the image may not fit

your TV screen. To change the aspect ratio,

see page 57.

Notes

• Do not connect more than one type of video cord

between the player and your TV at the same time.

• Do not use connections B and D at the same

time.

• Do not connect a VCR, etc., between your TV and

the player. If you pass the player signals via the

VCR, you may not receive a clear image on the

TV screen. If your TV has only one audio/video

input jack, connect the player to this jack.

Connector is upside

down

Not straight

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare