Sony DVP-NS708H Bedienungsanleitung PDF herunterladen (Seite 58)

58

◆ LINE

Selects video signals output from the LINE

(RGB)-TV jack on the rear panel of the

player.

Notes

• If your TV does not accept S video or the RGB

signals, no picture will appear on the TV screen,

even if you select “S VIDEO” or “RGB

(COMPONENT OFF).” Refer to the instructions

supplied with your TV.

• If your TV has only one SCART (EURO AV)

jack, do not select “S VIDEO.”

• If you set “LINE” to “RGB (COMPONENT

OFF)” in progressive mode, “PROGRESSIVE

(COMPONENT OUT ONLY)” will change from

“ON” to “OFF.”

◆ PROGRESSIVE (COMPONENT OUT

ONLY)

If your TV accepts progressive (525p/625p)

format signals, set “PROGRESSIVE

(COMPONENT OUT ONLY)” to “ON.”

Note that you must connect to a progressive

format TV using the COMPONENT VIDEO

OUT jacks (page 15).

To output progressive signals

1 Select “PROGRESSIVE

(COMPONENT OUT ONLY),” and

press ENTER.

2 Select “ON,” and press ENTER.

The display asks for confirmation.

3 Select “Start” and press ENTER.

The video switches to a progressive

signals for 5 seconds.

4 If the picture appears normal, select

“YES,” and press ENTER.

If not, select “NO,” and press ENTER.

To reset the setting

If the picture does not appear normal or goes

blank, press

[/1 to turn off the player, and

enter “369” using the number buttons on the

remote, then press

[/1 to turn on the player

again.

◆ MODE (PROGRESSIVE)

In order for these images to appear natural on

your screen when output in progressive

mode, the progressive video signal needs to

be converted to match the type of DVD

software that you are watching.

This setting is effective only when you set

“PROGRESSIVE (COMPONENT OUT

ONLY)” in “SCREEN SETUP” to “ON.”

◆ 4:3 OUTPUT

This setting is effective only when you set

“TV TYPE” in “SCREEN SETUP” to

“16:9.”

Adjust this to watch 4:3 aspect ratio. If you

can change the aspect ratio on your TV,

change the setting on your TV, not the player.

VIDEO Outputs video signals.

S VIDEO Outputs S video signals.

RGB

(COMPONENT

OFF)

Outputs RGB signals and no

component video signals.

OFF

To output normal (interlace)

signals.

ON To output progressive signals.

AUTO Automatically detects the

software type (film-based or

video-based) and selects the

appropriate conversion mode.

Normally, select this position.

VIDEO Fixes the conversion mode to

the mode for video-based

software.

FULL

Select this when you can

change the aspect ratio on your

TV.

NORMAL Select this when you cannot

change the aspect ratio on your

TV. Shows a 16:9 aspect ratio

signal with black bands on left

and right sides of the image.

16:9 aspect ratio TV

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare