Sony STR-DA5700ES Bedienungsanleitung PDF herunterladen (Seite 47)

Getting Started

Before using the receiver for the first time,

initialize the receiver by performing the

following procedure. This procedure can also

be used to revert back to the factory default

settings.

1 Press ?/1 to turn off the

receiver.

2 While holding down the TONE

MODE and 2CH/A.DIRECT,

press ?/1 to turn on the

receiver.

3 Release the TONE MODE and

2CH/A.DIRECT after a few

seconds.

The “MEMORY CLEARING...” appears

on the display window for a while, then

changes to “MEMORY CLEARED!”

Changes or adjustments made to the

settings are now reset to the defaults.

Note

It takes about one minute for the memory to be

cleared completely. Do not turn the receiver off until

“MEMORY CLEARED!” appears on the display.

Insert two R6 (size-AA) batteries in the

RM-AAL038 remote control, and the

RM-AAU124 remote control.

Observe the correct polarity when installing

batteries.

Notes

• Do not leave the remote control in an extremely hot

or humid place.

• Do not use a new battery with old ones.

• Do not mix manganese batteries and other kinds of

batteries.

• If you do not intend to use the remote control for an

extended period of time, remove the batteries to

avoid possible damage from battery leakage and

corrosion.

• When you replace or remove the batteries, the

programmed codes may be cleared. If this happens,

program the remote control codes again (page 120,

124, 125).

Performing initial setup

operations (clearing all

memorized settings)

?/1

TONE MODE 2CH/A.DIRECT

Inserting batteries into the

remote control

RM-AAL038 RM-AAU124

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 149 150

Kommentare zu diesen Handbüchern

Keine Kommentare

Sony STR-DA5700ES Bedienungsanleitung Seite 47

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für AV-Receiver Sony STR-DA5700ES