Sony LBT-LV60 Bedienungsanleitung PDF herunterladen (Seite 56)

56

Specifications

Amplifier section

The following measured at AC 220 V, 50/60 Hz

DIN power output (Rated)

150 + 150 watts

(6 ohms at 1 kHz, DIN)

Continuous RMS power output (Reference)

200 + 200 watts

(6 ohms at 1 kHz, 10 %

THD)

Inputs

PHONO IN (phono jacks):sensitivity 3 mV,

impedance 47 kilohms

MIC 1/2 (phono jack): sensitivity 1 mV,

impedance 10 kilohms

VIDEO 1 IN (phono jacks):sensitivity 250 mV,

impedance 47 kilohms

VIDEO 2 IN (phono jacks):sensitivity 250 mV,

impedance 47 kilohms

MD IN (phono jacks): sensitivity 450 mV,

impedance 47 kilohms

Outputs

PHONES (stereo phone jack):

accepts headphones of

8 ohms or more

VIDEO OUT (phono jack):voltage 250 mV,

impedance 1 kilohm

MD OUT (phono jacks): voltage 250 mV,

impedance 1 kilohm

FRONT SPEAKER : accepts impedance of 6 to

16 ohms

Video section

Inputs

VIDEO1 IN (phono jacks):1 V p-p, 75 ohms

VIDEO2 IN (phono jacks):1 V p-p, 75 ohms

Outputs

VIDEO OUT (phono jack):1 V p-p, 75 ohms

S-VIDEO OUT (4-pin/mini-DIN jack):

Y: 1 V p-p, unbalanced,

Sync negative,

C: 0.286 V p-p,

load impedance 75 ohms

The tape does not erase completely.

•The record/playback heads are

magnetized. Demagnetize them (see page

54).

There is excessive wow or flutter, or the

sound drops out.

•The capstans or pinch rollers are dirty.

Clean them (see page 54).

Noise increases or the high frequencies are

missing.

•The record/playback heads are

magnetized. Demagnetize them (see page

54).

Tuner

Severe hum or noise (“TUNED” or

“STEREO” flashes in the display).

•Adjust the antenna.

•The signal strength is too weak. Connect

an external antenna.

A stereo FM program cannot be received in

stereo.

•Press STEREO/MONO so “STEREO”

appears in the display.

If other problems not described

above occur, reset the system as

follows:

1 Unplug the power cord.

2 Plug the power cord back in.

3 Press c/CLOCK SET, ENTER, and

?/1 at the same time.

The system is reset to the factory settings. All

the settings you made, such as the preset

stations, clock, and timer are cleared. You

should set them again.

Troubleshooting (continued)

1 2 ... 51 52 53 54 55 56 57 58 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare