
19
1 Press (SOURCE) to select a desired
source.
2 Press (DSO) repeatedly to select the
desired DSO mode.
Each time you press (DSO), the DSO mode
changes.
After 3 seconds, the display returns to the
normal playback mode.
To cancel the DSO function, select “off.”
Notes
• Depending on the type of car interior or type of
music, DSO may not have a desirable effect.
• If FM broadcasts are difficult to hear, set DSO to
STD or off.
• If you have set the DSO mode to “WIDE” or “WIDE-
SP,” audible distortion may occur during poor (low
signal) radio reception. To eliminate this distortion,
set the DSO mode to “STD.”
Adjusting the DSO mode
Each of the 4 DSO modes has 3 adjustable effect
levels. The higher the effect level number, the
greater its effect.
1 Press (SOURCE) to select a source.
2 Press (MENU).
3 Press M or m repeatedly until “DSO
Tune” appears, then press (ENTER).
4 Press < or , to select the desired
DSO mode, then press (ENTER).
5 Press M or m to select the desired
effect level.
You can select one of the 3 effect levels for
each DSO mode.
To restore the factory-set effect level, press
(ENTER) for 2 seconds.
6 Press (ENTER).
Notes
• If you have set the DSO mode to “off,” you cannot
adjust the DSO mode.
• You cannot set the desired effect level on each
source.
Selecting the DSO setting best suited
for tweeters
1 During playback or radio reception,
press (MEN U).
2 Press M or m repeatedly to select
“DSO.”
3 Press , repeatedly to select “norm”
or “soft.”
“norm” is for a DSO setting.
“soft” is best suited for a DSO setting with
tweeters connected.
4 Press (ENTER).
Note
You cannot set this setting on each source.
Tip
Sound quality will change by selecting “norm” or “soft”
even without tweeters connected.
Kommentare zu diesen Handbüchern