
30
Error displays/Messages
*1 When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2 The disc number of the disc causing the error
appears in the display.
Automatic tuning is not possible.
• The local seek mode is set to “on.”
t Set the local seek mode to “off” (page
24).
• The broadcast signal is too weak.
t Perform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set to the monaural reception mode (page
24).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
t Cancel monaural reception mode (page
24).
Interference occurs during FM reception.
The wide mode is selected.
t Set the IF mode to “IF Auto” (page 15).
Sound setting
No sound or unclear sound
After adjusting “BAL” (balance), “F” (front),
or “R” (rear), the sound of a specific speaker
may get lower.
t Readjust “BAL” (page 21), “F” or “R”
(page 22).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about 5
seconds, and an alarm sound will be heard.
Blank*
1
No tracks have been recorded on an MD*
2
.
t Play an MD with recorded tracks on it.
Error*
1
• A CD is dirty or inserted upside down*
2
.
t Clean or insert the CD correctly.
• A CD/MD cannot play because of some
problem*
2
.
t Insert another CD/MD.
High Temp
The ambient temperature is more than 50°C.
t Wait until the temperature goes down
below 50°C.
NO Disc
No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.
NO Magazine
The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.
Not Ready
The lid of the MD unit (MDX-40) is open or
the MDs are not inserted properly.
t Close the lid or insert the MDs properly.
Push Reset
The CD/MD unit cannot be operated because
of some problem.
t Press the reset button on the unit.
Kommentare zu diesen Handbüchern